Connecting Your Tv Audio/Video With Rca To Scart Jacks; Modulator - NETGEAR MP115 User Manual

Connecting Your TV Audio/Video with RCA to SCART Jacks

• If you have a (SCART to RCA) A/V cable (not included) that one end of the A/V cable with RCA line
input jacks which has yellow, white, and red markings), and another end of the A/V cable with SCART
line input jack. Refer to the connection diagram given below, then connect the SCART line input jack
of the A/V cable to the Digital Media Player's SCART video jack. Connect the other ends of the A/V
cable to the AUDIO L/R and VEDIO jacks on the TV. Match the cable colors to the jack colors.
Connecting Your TV Video with RCA and Coaxial Cable via RF Modulator
Before you begin, make sure you have an RF modulator and extra RF coaxial cables. These are not
supplied with Digital Media Player, but are available from most consumer electronics retailers.
• Refer to the connection diagram given below. Connect the supplied video cable (which has yellow
marking) to the Digital Media Player's VIDEO jack. Connect the other ends of the cable to the
VIDEO jack on the RF modulator. The VIDEO jack on the RF modulator is usually yellow and might
be labeled VIDEO, CVBS, COMPOSITE, or BASEBAND.
• You probably already have an Antenna or Cable TV signal connected to the ANTENNA IN jack on
your TV. Disconnect it now from the TV. Reconnect the Antenna or Cable TV signal to the ANTENNA
2BDF0-020017 REV.00
Page 13 of 36