Connecting Tv And Digital Media Player Power - NETGEAR MP115 User Manual

Connect the other ends of the audio cable to the AUDIO L/R audio jacks on the TV. Match the cable
colors to the jack colors.

Connecting TV and Digital Media Player Power

• Plug the power cord (female) into the power inlet jack on the Digital Media Player. Plug the other end (
male) of the power cord into an active power outlet. Also plug the power cord of the TV into an active
power outlet. Make sure that the power cords are seated properly in Digital Media Player's receptacle
and in the AC wall outlet for TV and Digital Media Player.
Turn your Digital Media Player and TV on (change TV channels downward until you see the Digital
Media Player Setup Wizard screen saver on the TV). If you hooked up the audio to your stereo receiver,
turn your stereo receiver on as well. Tune the proper mode to match the audio connector attached to the
Digital Media Player.
2BDF0-020017 REV.00
Page 15 of 36