Mp115 Digital Media Player Front/Rear Panel Overviews - NETGEAR MP115 User Manual

MP115 Digital Media Player Front/Rear Panel Overviews

Before you continue, please take a moment to become familiar with the locating and purpose of controls,
the status panel, connectors, and ports, which are illustrated in the following:
MP115 Digital Media Player Front/Rear Panel Overviews
Appearance
2BDF0-020017 REV.00
Resource CD
Installation Guide
Warranty/Support Information Card
User's Manual
Definition
Infrared (IR) Sensor
Opening
Dual Wireless (802.11g/b)
Antenna
S-Video Out Jack
Functional Descriptions
The infrared (IR) sensor receives commands from
remote control. The IR sensor is located on lower-right
corner of the front of Digital Media Player.
The wireless antenna can rotate on connector (
perpendicular to the antenna base). You may want to
try several different angles -90 to +90 degrees for the
best reception. Minimum requirements of 802.11g/b
must be met.
Separate video, also called Y/C video. Separate luma (
Y) and chroma (C) video signals are used, rather than
a single composite video signal. By simply adding
together the Y and C signals, you generate a composite
video signal. The IEC 60933-5 standard specifies the
S-Video connector, including signal levels.
Connect an S-Video cable (not supplied) to the S-Video
jack on the Digital Media Player. Connect the other
ends of the S-Video cable to the S-Video jack on the
TV.
Page 9 of 36