Associating A Virtual Fibre Channel Interface To A Vsan - Cisco Nexus 7000 series Configuration Manual

Configuring FCoE VLANs and Virtual Interfaces
Command or Action
Step 3
switchport mode mode
Example:
switch(config-if)# switchport mode e
Step 4 show interface vfc-port-channel int-number
Example:
switch(config-if)# show interface
vfc-port-channel 2
Step 5
copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config

Associating a Virtual Fibre Channel Interface to a VSAN

You must configure unique, dedicated VLAN at every converged access switch to carry traffic for each Virtual
Fabric (VSAN) in the SAN (for example, VLAN 1002 for VSAN 1, VLAN 1003 for VSAN 2, and so on). If
you enable MST, you must use a separate MST instance for FCoE VLANs.
Before You Begin
For Cisco Nexus 7000 Series Switches, ensure that you are in the storage VDC.
SUMMARY STEPS
1. configure terminal
2. vsan database
3. (Optional) vsan vsan-id
4. Enter one of the following commands:
5. (Optional) show vsan
6. (Optional) copy running-config startup-config
OL-25809-02
• vsan vsan-id interface vfc vfc-id
• vsan vsan-id interface vfc-port-channel vfc-id
Associating a Virtual Fibre Channel Interface to a VSAN
Purpose
Configures the switchport mode for a virtual Fibre Channel
interface. The mode is E or F. The default is F mode.
(Optional)
Displays information about the virtual Fibre Channel interfaces
bound to port channel interfaces.
(Optional)
Copies the running configuration to the startup configuration.
Cisco NX-OS FCoE Configuration Guide for Nexus 7000 and MDS 9500
29