Makita DF012D Instruction Manual page 7

Guideline for clutch auto stop
Work range of clutch auto-stop
High
-
-
-
-
-
When driving machine screws
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the light, slide the lamp switch to the A
position. To turn off the light, slide the lamp switch to B
position.
Even if you leave the lamp on, the light will automati-
cally turn off after 5 minutes.
B
A
► 1 . Lamp switch 2. Lamp
NOTE: The lamp signals by flickering during use
when the battery power is almost used up.
At this time, recharge the battery or replace the bat-
tery with a fully charged one.
Low
-
-
Increments
1
2
Increments on adjusting ring
for fastening torque
1
5
9
13
17
21
1 - 3
4 - 8
9 - 18
19 - 21
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
Use only driver bit/socket bit that has inserting portion
shown in the figure. Do not use any other driver bit/
socket bit.
7 ENGLISH
Fastening torque
Approx. 0.3 N•m
(Approx. 3 Kgf•cm)
Approx. 0.82 N•m
(Approx. 8.4 Kgf•cm)
Approx. 1.35 N•m
(Approx. 13.8 Kgf•cm)
Approx. 1.88 N•m
(Approx. 19.2 Kgf•cm)
Approx. 2.41N•m
(Approx. 24.6 Kgf•cm)
Approx. 2.9 N•m
(Approx. 30 Kgf•cm)
At low speed, approx. 8 N•m
(Approx. 81.6 Kgf•cm)
At high speed, approx. 1.5 N•m
(Approx. 14.7 Kgf•cm)
Guideline for machine screw diameter
2.5 mm
3 mm
4 mm
5 mm