Cisco 380 Series Hardware Installation Manual page 32

Figure 2-1
1
6
1 Front-right rack post
2 Rear-right rack post
3
Slide-rail assembly
Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail
c.
assemblies are level and at the same height with each other.
d. Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops
and lock in place.
Insert the appliance into the slide rails (see
Step 2
This appliance weighs approximately 60 pounds (28 kilograms) when fully loaded with components. We
Caution
recommend that you use a minimum of two people when lifting the appliance. Attempting this procedure
alone could result in personal injury or equipment damage.
Note
Align the inner rails that are attached to the appliance sides with the front ends of the empty slide
a.
rails.
Push the appliance into the slide rails until it stops at the internal stops.
b.
Push in the slide rail locking clip (item 2) on each inner rail, and then continue pushing the appliance
c.
into the rack until its front flanges latch onto the rack posts.
Cisco 380 and Cisco 680 Series Hardware Installation Guide
2-6
Attaching a Slide-Rail Assembly
3
The inner rails are pre-attached to the sides of the appliance at the factory. You can order
replacement inner rails if these are damaged or lost (Cisco PID CCS-RAIL=).
4
4 Length-adjustment bracket
5 Mounting pegs (two on each end of assembly)
6
Locking clips (one on each end of assembly)
Figure 2-2):
Chapter
2
6
OL-29172-01
5