Siemens sinumerik 840D sl Operating Manual page 411

Turning
Hide thumbs Also See for sinumerik 840D sl:
Table of Contents

Advertisement

Parameters
Description
Lift mode
Lift mode before new infeed
If the machining operation requires several points of insertion, the retraction height can
be programmed:
to RP
Z0 + safety clearance - (only for G code and ShopTurn, machining surface, face
C/Y/B) or
X0 + safety clearance - (only for ShopTurn, machining surface, peripheral surface
C/Y)
On making the transition to the next insertion point, the tool returns to this height. If
there are no elements larger than Z0 (X0) in the pocket area, then Z0 (X0) + safety
clearance can be programmed as the lift mode.
FS
Chamfer width for chamfering - (only for chamfering machining)
ZFS
Insertion depth of tool tip (abs or inc) - (for chamfering machining only)
Turning
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
Programming technology functions (cycles)
8.5 Contour milling
Unit
mm
mm
mm
mm
mm
411

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 828d

Table of Contents