Programming technology functions (cycles)
8.5 Contour milling
Procedure for deleting a contour element
8.5.6
Contour call (CYCLE62) - only for G code program
Function
The input creates a reference to the selected contour.
There are four ways to call the contour:
1. Contour name
2. Labels
3. Subprogram
4. Labels in the subprogram
Procedure
390
1.
Open the part program or ShopTurn program to be executed.
2.
Position the cursor on the contour element that you want to delete.
3.
Press the "Delete element" softkey.
4.
Press the "Delete" softkey.
The contour is in the calling main program.
The contour is in the calling main program and is limited by the labels that have been
entered.
The contour is located in a subprogram in the same workpiece.
The contour is in a subprogram and is limited by the labels that have been entered.
1.
The part program or ShopTurn program to be processed has been
created and you are in the editor.
2.
Press the "Milling" and "Contour milling" softkeys.
3.
Press the "Contour" and "Contour call" softkeys.
The "Contour Call" input window opens.
4.
Assign parameters to the contour selection.
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
Turning