Parameters, G code program
PL
Machining plane
SC
Safety clearance
F
Feedrate
Parameters
Machining
Position
X0
Z0
B1
T1
D
UX or U
UZ
N
DP
α1, α2
Turning
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
- OR
Groove cycle on an incline with inclines, radii or chamfers.
The "Groove 3" input window opens.
mm
mm/min
Description
∇ (roughing)
∇∇∇ (finishing)
∇ + ∇∇∇ (roughing and finishing)
Groove position:
Reference point in X ∅
Reference point in Z
Groove width
Groove depth ∅ (abs) or groove depth referred to X0 (inc)
Maximum depth infeed for insertion – (only for ∇ and ∇ + ∇∇∇)
For zero: Insertion in a cut – (only for ∇ and ∇ + ∇∇∇)
D = 0: 1. cut is made directly to final depth T1
D > 0: 1st and 2nd cuts are made alternately to infeed depth D, in order to achieve
a better chip flow and prevent the tool from breaking, refer to
approaching/retraction when roughing.
Alternate cutting is not possible if the tool can only reach the groove base at one
position.
Finishing allowance in X or finishing allowance in X and Z – (only for ∇ and ∇ +
∇∇∇)
Finishing allowance in Z – (for UX, only for ∇ and ∇ + ∇∇∇)
Number of grooves (N = 1....65535)
Distance between grooves (inc)
DP is not displayed when N = 1
Flank angle 1 or flank angle 2 - (only for grooves 2 and 3)
Asymmetric grooves can be described by separate angles. The angles can be
between 0 and < 90°.
Programming technology functions (cycles)
Parameters, ShopTurn program
T
Tool name
D
Cutting edge number
F
Feedrate
S / V
Spindle speed or constant
cutting rate
8.2 Rotate
mm/min
mm/rev
rpm
m/min
Unit
mm
mm
mm
mm
mm
mm
mm
Degrees
285