Bevel Cutting; Operation - Makita M4302 Instruction Manual

► 1 . Roller 2. Saw blade
Loosen the hex bolt on the back of the base with
the hex wrench. Move the retainer so that the roller
contacts the blade lightly. Then tighten the hex bolt to
secure the base and the retainer.
However, when using the blade that does not have a
straight back, slide the retainer back so that the roller
will not contact the blade.
NOTE:
• Occasionally lubricate the roller.
Hex wrench storage
► 1 . Hex wrench
When not in use, the hex wrench can be conveniently
stored.

OPERATION

CAUTION:
• Hold the tool irmly with one hand on the main
handle when using the tool. If necessary, the
front part of the tool may be supported by the
other hand.
• Always hold the base lush with the workpiece.
Failure to do so may cause blade breakage,
resulting in serious injury.
• Advance the tool very slowly when cutting
curves or scrolling. Forcing the tool may cause a
slanted cutting surface and blade breakage.
1
2
1
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest
the base lat on the workpiece and gently move the tool
forward along the previously marked cutting line.

Bevel cutting

CAUTION:
• Always be sure that the tool is switched off and
unplugged before tilting the base.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
► 1 . Hex wrench 2. Hex bolt
Loosen the bolt on the back of the base with the hex
wrench and slide the base backwards.
5 ENGLISH
1
2