Ip Igmp Snooping Vlan Mrouter - Cisco Catalyst 3650 series Command Reference Manual

ip igmp snooping vlan mrouter

ip igmp snooping vlan mrouter
To add a multicast router port, use the ip igmp snooping mrouter global configuration command on the
device stack or on a standalone device. To return to the default settings, use the no form of this command.
Command Default
By default, there are no multicast router ports.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMP snooping.
The configuration is saved in NVRAM.
Examples
This example shows how to configure a port as a multicast router port:
Device(config)# ip igmp snooping vlan 1 mrouter interface gigabitethernet1/0/2
You can verify your settings by entering the show ip igmp snooping privileged EXEC command.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
228
Modification
This command was introduced.