Switchport Port-Security Aging - Cisco Catalyst 3650 series Command Reference Manual

switchport port-security aging

To set the aging time and type for secure address entries or to change the aging behavior for secure addresses
on a particular port, use the switchport port-security aging command in interface configuration mode. To
disable port security aging or to set the parameters to their default states, use the no form of this command.
switchport port-security aging {static| time time| type {absolute| inactivity}}
no switchport port-security aging {static| time| type}
Syntax Description
static
time time
type
absolute
inactivity
Command Default
The port security aging feature is disabled. The default time is 0 minutes.
The default aging type is absolute.
The default static aging behavior is disabled.
Command Modes
Interface configuration
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
To enable secure address aging for a particular port, set the aging time to a value other than 0 for that port.
To allow limited time access to particular secure addresses, set the aging type as absolute. When the aging
time lapses, the secure addresses are deleted.
To allow continuous access to a limited number of secure addresses, set the aging type as inactivity. This
removes the secure address when it become inactive, and other addresses can become secure.
Enables aging for statically configured secure addresses on this port.
Specifies the aging time for this port. The range is 0 to 1440 minutes. If the time
is 0, aging is disabled for this port.
Sets the aging type.
Sets absolute aging type. All the secure addresses on this port age out exactly after
the time (minutes) specified and are removed from the secure address list.
Sets the inactivity aging type. The secure addresses on this port age out only if
there is no data traffic from the secure source address for the specified time period.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
switchport port-security aging
Modification
This command was introduced.
831