Operation - Makita DA3010 Instruction Manual

Lighting up the lamps
4
5
1
003795
For Model DA3010F, DA3011F
CAUTION:
Do not look in the light or see the source of light
•
directly.
To turn on the lamp, start the tool. Then, the lamp lights
up the top of the bit. To turn it off, stop the tool.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing side grip (handle)
003797
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Screw the side grip on the tool securely. The side grip
can be installed on either side of the tool, whichever is
convenient.
1. Lamp
2. Speed control
screw
3. Switch lever
4. Higher
5. Lower
3
2
Installing or removing drill bit
For Model DA3010, DA3010F
003798
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each
of the three holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise
in just one hole, then loosen the chuck by hand.
After using the chuck key, be sure to return to the
original position.
For Model DA3011, DA3011F
1
2
004649
Hold the ring and turn the sleeve counterclockwise to
open the chuck jaws. Place the bit in the chuck as far as
it will go. Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck.
To remove the bit, hold the ring and turn the sleeve
counterclockwise.

OPERATION

Holding the tool
2
003861
Hold the tool firmly with one hand on the gripping part of
the tool and the other hand on the side grip when
performing the tool.
5
1. Chuck key
1
1. Sleeve
2. Ring
1. Gripping part
1
2. Side grip
(handle)