Operating Instructions; Placement; Routing The Camera - RIDGID seesnake compact2 Operator's Manual

Operating Instructions

Wear appropriate protective equipment such as
latex or rubber gloves, goggles, face shields, and
respirators when inspecting drains that might con-
tain hazardous chemicals or bacteria. Always wear
eye protection to protect against dirt and other for-
eign objects.
Do not operate equipment if operator or equipment
are standing in water. Operating the equipment
while in water increases the risk of electrical shock.
Rubber-soled, non-slip shoes can help prevent slip-
ping and electrical shock on wet surfaces.

Placement

Place the SeeSnake Compact2 and the CS6Pak near
the pipe entrance so you can manipulate the push cable
while viewing the display.
Placing the Compact2 where the drum cannot spin free-
ly may result in the push cable over-winding inside the
drum. Over-winding the push cable may result in proper-
ty damage and/or serious injury. During operation, place
the Compact2 in a stable location and make sure the
drum can spin freely. Do not pull the push cable out of
the drum unless the drum can spin freely.
10 – English
Find Quality Products Online at:
WARNING
GlobalTestSupply
www.

Routing the Camera

If the camera is inside the drum, you must route the
camera through the push cable guides. The push cable
and camera head should be threaded through all three
guides.
1. Lock open the spring clip.
2. Reach inside the drum and find the camera.
3. Insert the camera through the inner push cable guide
and then through the two outer push cable guides.
4. Return the spring clip to the operation position to se-
cure the spring and prevent the push cable from re-
tracting back into the drum.
.com
sales@GlobalTestSupply.com