Position The Asa - Cisco ASA 5506W-X Hardware Installation Manual

Position the ASA

This product requires short-circuit (overcurrent) protection to be provided as part of the building installation.
Warning
Install only in accordance with national and local wiring regulations.
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
Warning
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available.
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Warning Installation of the equipment must comply with local and national electrical codes.
The device is designed to work with TN power systems.
Warning
Position the ASA
Whether positioning the ASA on a desktop, on a non-rack closet shelf, or mounting it on a wall, consider the
following:
Do not stack the ASA chassis on top of another ASA chassis. If you stack the units, they will overheat,
Caution
which causes the units to power cycle.
Cisco ASA 5506-X, ASA 5506W-X, and ASA 5506H-X Hardware Installation Guide
24
Installation Preparation
Online Only