System Log Commands - D-Link DXS-1210-12TC Reference Manual

44. System Log Commands

44-1
This command is used to delete log messages in the system logging buffer.
clear logging
Parameters
None.
Default
None.
Command Mode
Privilege EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
This command deletes all the log messages in the system logging buffer.
Example
This example shows how to delete all the log messages in the logging buffer.
Switch# clear logging
Clear logging? (y/n) [n] y
Switch#
44-2
This command is used to enable logging of system messages to the local message buffer. Use the no
form of this command todisable the logging of messages to the local message buffer. Use the default
logging buffered command to revert to default setting.
logging buffered [severity {SEVERITY-LEVEL | SEVERITY-NAME}] [write-delay {SECONDS |
infinite}]
no logging buffered
default logging buffered
Parameters
SEVERITY-LEVEL
SEVERITY-NAME
DXS-1210 Series Smart Managed Switch CLI Reference Guide
clear logging
logging buffered
(Optional) Specifies the severity level of system messages. The
messages at that severity level or a more severe level will be logged to
message buffers. This value must be between 0 and 7. 0 is the most
severe level. If not specified, the default severity level is warnings (4).
(Optional)Specifies the severity level of system messages by one of
the following names: emergencies, alerts, critical, errors, warnings,
notifications, informational, debugging.
341