Ipv6 Enable; Ipv6 Neighbor - D-Link DXS-1210-12TC Reference Manual

Use this command to configure the interface to use DHCPv6 to get an IPv6 address. When the no
ipv6 address dhcp command is used, the previous DHCPv6 obtained IP address will be removed. If
the rapid commit keyword is specified for the command, the rapid commit option will be included in
the solicit message to request for the two-message exchange for address delegation.
Example
This example shows how to configure VLAN 1 to use DHCPv6 to get an IPv6 address.
Switch# configure terminal
Switch(config)#interface vlan 1
Switch(config-if)# ipv6 address dhcp
Switch(config-if)#

9-4 ipv6 enable

This command is used to enable IPv6 processing on interfaces that have no IPv6 address explicitly
configured. Use the no form of this command to disable IPv6 processing on interfaces that have no
IPv6 address explicitly configured.
ipv6 enable
no ipv6 enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When the IPv6 address is explicitly configured on the interface, the IPv6 link-local address is
automatically generated and the IPv6 processing is started. When the interface has no IPv6 address
explicitly configured, the IPv6 link-local address is not generated and the IPv6 processing is not
started. Use the ipv6 enable command to auto-generate the IPv6 link-local address and start the IPv6
processing on the interface.
Example
This example shows how to enable IPv6 on interface VLAN 1, which has no IPv6 address explicitly
configured.
Switch# configure terminal
Switch(config)#interface vlan 1
Switch(config-if)# ipv6 enable
Switch(config-if)#

9-5 ipv6 neighbor

This command is used to create a static ipv6 neighbor entry. Use the no form of this command to
delete a static IPv6 neighbor entry.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
89