Switch#show lldp
LLDP System Information
Chassis ID Subtype
Chassis ID
System Name
System Description
System Capabilities Supported: Repeater, Bridge
System Capabilities Enabled
LLDP-MED System Information:
Device Class
Hardware Revision
Firmware Revision
Software Revision
Serial Number
Manufacturer Name
Model Name
Asset ID
PoE Device Type
PoE PSE Power Source
LLDP Configurations
LLDP State
LLDP Forward State
Message TX Interval
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
25-20
This command is used to display the LLDP configuration at the physical interface.
show lldp interface INTERFACE-ID[, | -]
Parameters
INTERFACE-ID
,
-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the LLDP information of each physical interface.
Example
DXS-1210 Series Smart Managed Switch CLI Reference Guide
show lldp interface
Specifies to display the LLDP configuration for a specific interface.
Valid interfaces are physical interfaces.
(Optional) Specifies a series of physical interfaces. No spaces before
and after the comma.
(Optional) Specifies a range of physical interfaces. No spaces before
and after the hyphen.
: MAC Address
: 3C-1E-04-A1-CC-00
: Switch
: Gigabit Ethernet SmartPro Switch
: Repeater, Bridge
: Network Connectivity Device
: A1
: 1.00.012
: 1.30.003
:
: D-Link Corporation
: DXS-1210-28XMP Gigabit Ethernet
:
: PSE Device
: Primary
: Disabled
: Disabled
: 30
191