Cisco TelePresence MX700 Installation Manual page 16

Installation guide for Cisco TelePresence MX700 Single camera - Wall mount
12
Fasten right monitor and connect power cable
4 × M6x35, countersunk
2 × M6x90, countersunk
2 × M6x100, pan
2 × Bracket
Enter the following screws:
1
• Four M6x35 screws, from front.
• Two M6x90 screws, from underneath.
• Two M6x100 screws and their brackets, from
underneath.
Then, tighten all screws.
78-100254-03A0 | 2016 JUNE | © 2016 Cisco Systems, Inc. All rights reserved.
Rear view
Connect power cable
2
Connect the loose end of the power cable from
step 10 to the close-by socket at the rear of the right
monitor. The socket must be reached from below.
Make sure that the power switch next to the socket is
in its ON position.
Left side of the
monitor, viewed
from underneath
Right side of the
monitor, viewed
from underneath
Page 16