Cisco TelePresence MX700 Installation Manual page 11

Installation guide for Cisco TelePresence MX700 Single camera - Wall mount
7
Fasten clamps on monitors
A, D
While the monitors are still in the package,
mount the clamps on the rear side of both
monitors.
78-100254-03A0 | 2016 JUNE | © 2016 Cisco Systems, Inc. All rights reserved.
1
Use the Allen key 2.5 mm
and loosen, but do not
remove, the premounted
screws.
3
Push the support bracket
tight against the back plate
of the monitor.
2
Slide the clamp in place on
the monitor and make sure
that all the small clamps are
properly fitted.
4
Tighten the screws and
check that the clamp is
properly fastened.
Page 11