Consoles, Front And Rear - Honda Civic 2002 Service Manual

4. Remove the headliner.
-1 Remove the socket plug (A).
- 2 R e m o v e t h e r e m a i n i n g d o o r o p e n i n g t r i m { B }
from each roof portion.
-3 Detach the clips (C), and release the fasteners
( D ) b y p u l l i n g t h e f r o n t p o r t i o n o f t h e h e a d l i n e r
(E) down.
-4 With the help of an assislant, release the clips
(F) of the headliner from the moonroof frame
( G ) , a n d r e l e a s e t h e h e a d l i n e r f r o m t h e c l i p s ( H )
by sliding the headliner forward, and lowering
t h e h e a d l i n e r .
-5 Remove the headliner through the passenger's
o p e n i n g .
Fastener Locations
C > : C l i p , 3
a
o
5 . Install the headliner in the reverse order of removal,
and note these items:
. W h e n r e i n s t a l l i n g t h e h e a d l i n e r t h r o u g h t h e
passenger's door opening, be careful not to fold
or bend it, Also, be careful not to scratch the
DOOy.
. C h e c k t h a t b o t h s i d e s o f t h e h e a d l i n e r a r e
securely attached to the trim.
. R e p l a c e a n y c l i p s t h a t r e m a i n i n t h e r o o f d u r i n g
r e m o v a l . R e i n s t a l l t h e c l i p s b a c k i n t h e h e a d l i n e r
before installation.
F > : C l i p , 2 H > : C l i p , 2
Carpet Replacement
SRS components are located in this area. Reviewthe
SRS component locations (see page 23-13) and the
precautions and procedures (see page 23-14) in the SRS
section before performing repairs or service.
NOTE:
. Put on gloves to protect your hands.
. Take care not to damage, wrinkle. or twist the carpet.
. Be careful not to damage the dashboard or other
interior trim pieces.
1. Remove these items:
. Front seats, both sides (see page 20-111
. Driver's dashboard under cover (see page 20-60)
. Passenger's dashboard Iower cover (see page
20-631
. Rear seat cushion (see page 20-80)
. Kick panels, both sides (see page 20-50)
. Door silltrim, both sides (see page 20-50)
. Consoles, front and rear (see page 20-57)
2 . R e m o v e t h e n u t ( A ) , a n d u s i n g a h e x w r e n c h ,
release the clip (B), then remove the footrest (C).
Fastener Locations
A a : N u t , 1 B ) : C l i p , ' l
--'1
I
--\
-JrL
tj I
;tt4f
=\-/
l[il
A
6 x 1 . 0 m m
9 . 8 N m
11.0 kgf m,7.2 lbf.ft)
- o
(cont'd)
20-55