Powering Off The Cs1000 - RIDGID SeeSnake CS1000 Operator's Manual

Figure 42 – Resume Job from Job Manager
You can re-open and modify closed jobs by performing the
following:
1� Press the Job Manager Key
2� Use the down Arrow Key
Job" and press the Select Key
3� Use the up and down Arrow Keys
the job you want to resume� When the blue outline is
around the "Resume Job" icon
to resume press the Select Key
Figure 43 – Resuming a Closed Job

Powering OFF the CS1000

Power OFF your CS1000 by pressing the Power Key
either on the Main Keypad or on Mini Keypad� There will
be a 3-second power down countdown after you press the
Power Key � Cancel the power down countdown by press-
ing any of the keys on the main keypad�
Close or Pause a Job
If you try to power OFF the CS1000 when a job is open you
will be asked if you want to close or pause the job before
powering down�
22 – English
TM
to navigate to "Resume
�
to navigate to
of the job you want
�
Figure 44 – Close or Pause a Job
• Choose "Close Job and Power Down" to close the
job and turn OFF the CS1000� To resume the job in the
future select if from your "Resume Job" list�
• Choose "Pause Job and Power Down" to pause the
job and turn OFF the CS1000� The next time you turn
the CS1000 ON you will be asked if you want to re-
sume your paused job� This is especially convenient if
you want to take a quick break without using your bat-
teries or if you want to move to a new inspection entry
point at the same job location�
Abnormal Shutdown
If the CS1000 powers OFF abnormally, the equipment will
perform a systems check to inspect and repair any damage
the next time it powers ON� A systems check can take a
few minutes� The following events may result in a systems
check:
• An unexpected power outage during use�
• Unplugging the CS1000 when it is still ON�
Recycling Jobs
Remove Jobs from the Job Browser by sending them to the
Recycle Bin�
Figure 45 – Select Jobs to Recycle