Connecting The Lt1000; Powering The Seesnake Lt1000 - RIDGID SeeSnake LT1000 Manual

SeeSnake
Figure 23 – LT1000 Mini with Laptop

Connecting the LT1000

External
A/V Out Video Out
Power Jack
Figure 24 – LT1000 Connections
Connection Icons
External Power Jack
A/V Out Jack (External DVDR, etc.)
Video Out Jack (External Monitor)
USB Port (Thumb Drives, etc)
The USB ports may be used to connect an external
keyboard if desired.
The front AV out jack will work even when HQ is not
being used.
External Monitor Options
1. The LT1000 may be used with an external SeeSnake
monitor by connecting an RCA cable from the Video
IN port on the monitor. Connect the other end of the
cable to the LT1000 video OUT port on the back of
the LT1000, marked with
2. The A/V OUT port
from the SeeSnake camera connected to the LT1000
12
® LT1000
USB USB
.
will pass through live video
and live audio from the microphone out to a DVDR or
monitor. (If connected to a monitor which has speak-
ers it may cause a feedback squeal; this can be pre-
vented by turning the DVDR or monitor volume to
minimum.)
The USB connection from the LT1000 only functions
when connected to a device running SeeSnake HQ.

Powering the SeeSnake LT1000

The SeeSnake LT1000 can either be powered with a
RIDGID Li-Ion rechargeable battery or plugged into an
outlet using a supplied AC/DC power converter. Battery
power is the preferred powering method to reduce the
risk of electrical shock. Additionally, the power con-
verter is not rated for outdoor use and should only
be used indoors.
Use only a battery or an isolated power
WARNING
supply to power the LT1000 and any laptop used with it to
reduce the risk of Electrical shock.
Battery Power
With dry hands, insert a charged 18V battery into the bat-
tery holder under the right side of the keypad. A spare
battery may also be stored in the spare battery holder
under the opposite end of the LT1000 on the opposite
side. (The storage slot has no electrical connections
and is for convenient storage only.)
Battery
Status
Figure 25 – LT1000 Connections
Make sure that the battery locks onto the dock. See
the Battery Charger operator's manual for more infor-
mation.
Batteries supplied for the LT1000 are rated at 2.2 amp-
hours. When fully charged, depending on use (recording
time, etc.) the LT1000 will run for approximately 2.5 to 3
hours. Battery Status LEDs above keypad indicate battery
charge level. (See Battery Status LED chart . )
Turn the LT1000 power OFF before chang-
NOTICE
ing or removing the battery. Removing the battery with
the power ON may cause loss of camera recordings.
Battery
Battery