Table of Contents
Advertisement
How to set the Baud Rate
Through the PC Demo Interface
1) Connect the device and run PC Demo
2) Go to Tune Parameters / Serial Output page through the main menu of the program
3) Select the baud rate
4) Power down the device
5) Power up the device and communicate with the new baud rate
Through Direct Commands
1) Set up normal communications with the current baud rate
2) Issue the commands (see Section 4.4 of the User's Guide and Baud Rate)
3) Power down the device
4) Power up the device and communicate with the new baud rate
900240 Rev. B
3/01
page 24
Advertisement
Table of Contents
