Threading The Bobbin Case - AEG 110 User Manual

Preparing
To
Sew
Step 10

Threading the bobbin case

Shuttle cover
Bobbin case
Latch
Tension spring
Ensure the Power Switch
turned off when removing or
inserting the bobbin case.
a: Remove the sewing table from
the machine by pulling it to the left.
Open the Shuttle Cove
down the tab on the left of the cover.
Raise the needle to its highest
position by rotating the hand wheel
towards you.
b: To remove the Bobbin Case
from the shuttle pull back the Latch
on the bobbin case and pull
straight out of the shuttle.
c: Place a Bobbin
Case ,making sure the thread
feeds clockwise from the bobbin.
d: Draw the thread through the slot
in the case.
e: Continue to draw the thread under
the Tension Spring
the opening.
Note:
Pull out about 4" (10cm) of thread.
is
by pulling
in the Bobbin
and through
11