Hitachi Compute Blade 500 Series User Manual page 252

How to Change MAC address
Place the cursor on the crossing item of the LPAR in line and the virtual NIC
number in the column, and press [F6]: Change MAC Add to display the sub-
screen. Enter the new value and press [Enter]. Values to set range from
00:00:00:00:00:00 to FF: FF: FF: FF: FF: FF. The value reserved by LPAR
manager, however, cannot be set. Do not set a multi-cast address and
broadcast address.
Note:
• It is not recommended to change the MAC address.
Confirm that there is not the same MAC address port on the network
before changing the MAC address. Otherwise, the fatal failure may occur
on the network.
How to change VLAN mode
Note:
• When VF NIC is assigned, you can specify only [All] to Tagged VLAN ID.
• Do not change VLAN settings for VF NIC assigned to an activated LPAR.
Place the cursor on the intersection between the LPAR in line and the virtual
NIC number in column, and press [F7]: Select VLAN to display the sub-
screen. Select the VLAN mode and press [Enter].
7-48
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Figure 7-16 Promiscuous Mode Setting Screen
Operation by LPAR manager Screen