Hitachi Compute Blade 500 Series User Manual page 251

No. Item
(9) TXRATE
(10) ACT
Note:
• If the VLAN ID is not defined in the network segment identifier specified
by the cursor and [F2]: Disp VLAN ID Map is pressed, a message 'VLAN
ID is not set.' is displayed.
How to change Promiscuous Mode
Note:
• When VF NIC is assigned, you can only select "Restricte".
Place the cursor on the crossing item of the LPAR in line and the virtual NIC
number in column, and press [F5]: Set Prom. Mode to show a sub-screen.
Select a promiscuous mode and press [Enter].
Table 7-20 Details of Promiscuous Mode
Promiscuous Setting
Guest OS
Disable Restricted/Through
Enable Restricted
Through
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
[LPAR manager firmware version 01-9X or later]
When VF NIC is assigned, a limited transmission bandwidth of
LPAR is displayed.
[LPAR manager firmware version 01-9X or later]
When VF NIC is assigned, a state of LPAR is displayed.
Y(Activate): Activated LPAR
N(Deactivate): Deactivated LPAR
LPAR manager
Screen
Receives packets with the address only to
the concerned LPAR(MAC).
Receives packets with the address only to
the concerned LPAR(MAC).
Receives all packets on the identical network
segment.
Description
Receiving Packets
7-47