NETGEAR WNR612 User Manual page 82

Netgear WNR612 Wireless Router User Manual
The following table describes parameters in this page:
Field
Service Name Enter the service name.
You can select Any or Single address.
Any: Allow everybody in the user network to use the service.
Service User Single address: Enter the IP address of the network card on
the PC. Then, the service is applied only on the specific
network card of the PC.
Indicate the protocol used at the triggering port. You can select
Service Type
TCP/UDP, TCP, or UDP.
Triggering Unless this port generates the traffic, the input connection service
Port cannot be triggered.
Connection
You can select TCP/UDP, TCP, or UDP.
Type
When the connection to the triggering port is successful, the
Starting Port corresponding ports are open and the application can send
consequent connection request to the open ports.
Description
79