Placing A Phone Call; Answering Calls; Ending A Call; Muting A Call - Cisco 8831 User Manual

PLACING A PHONE CALL

1. Enter a phone number (10-digit phone number) you want to reach
2. Press [Dial] or speakerphone button

ANSWERING CALLS

1. press [Answer] softkey,or press the speakerphone button

ENDING A CALL

1.
Press [End Call] or speakerphone button

MUTING A CALL

1. Press the Mute
Press the Mute
2.
Note: Sound Base lights turn from red to green when not muted, and the DCU mute button is no longer red
Conference
Before You Begin
Before you can add a party to the conference, you must be on an active call and not on hold.
Step 1 Press Conf.
Step 2 Enter the phone number or speed-dial number for the party you want to add.
If you have several held calls, you can press Calls to display a caller list and add a caller to the conference.
Step 3 After the new party answers, press Conf.
The conference begins.
Step 4 (Optional) Repeat these steps to add more parties, if desired.
View Conference participants
Step 1 press ConfList to view a listof current participants
Remove Conference participants
Step 1 While in a conference, press ConfList to view a list of participants.
Step 2 Highlight the participant that you want to remove and then press Remove.

Create conference with two calls on same line

Step 1 With two connected calls on the same line, select a call to make it the active call.
The second call is put on hold.
Step 2 Press Conference.
Step 3 Press Calls to view the call list and select the caller to add to the conference.
Step 4 Wait for the call to connect.
Step 5 Press Conference to add the participant to your call.
The conference begins.
Divert
Step 1 Press Divert to send an incoming call to Voice Mail.
Note: available if extension is setup to receive voice mail
to disconnect the current call
button on the Sound Base or DCU. (Off =
button again to deactivate.
On = ) (solid red LED light when muted.
Pg. 4