Makita DUR184L Instruction Manual page 13

3. Hook the middle of the new nylon cord to the
notch located at the center of the spool between the 2
channels provided for the nylon cord.
Wind both ends firmly around the spool in the direction
marked on the head for right hand direction indicated
by RH.
4. Wind all but about 100 mm (4") of the cords, leav-
ing the ends temporarily hooked through a notch on the
side of the spool.
5. Mount the spool on the cover so that the grooves
and protrusions on the spool match up with those on the
cover. Now, unhook the ends of the cord from their tem-
porary position and feed the cords through the eyelets
to come out of the cover.
6. Align the protrusion on the underside of the cover
with the slots of the eyelets. Then push the cover firmly
onto the housing to secure it. Make sure the latches
fully spread in the cover.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
13 ENGLISH