Display Fc Domain - HP 6127XLG Blade Series Command Reference Manual

To successfully configure an allowed domain ID list on a non-principal switch, make sure the runtime
domain ID of the switch is included in the allowed list. After you configure an allowed domain ID list on
a non-principal switch, the following rules apply:
• The locally configured domain ID must be included in the allowed list. Otherwise, the domain ID
configuration fails.
The principal switch must assign a domain ID that is included in the allowed list of the non-principal
•
switch. Otherwise, the non-principal switch refuses the assigned domain ID and isolates its interface
connected to the principal switch.
HP recommends that you configure the same allowed domain ID list on all switches in a VSAN.
Examples
# Configure VSAN 1 to allow domains 3 through 10.
<Sysname> system-view
[Sysname] vsan 1
[Sysname-vsan1] allowed-domain-id 3 to 10

display fc domain

Use display fc domain to display the domain information of VSANs.
Syntax
display fc domain [ vsan vsan-id ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
vsan vsan-id: Specifies a VSAN by its ID in the range of 1 to 3839. If you do not specify a VSAN, this
command displays the domain information of all VSANs. On an FCF-NPV switch, this command displays
the domain information of only VSANs operating in FCF mode.
Usage guidelines
Only FCF and FCF-NPV switches support this command.
The displayed domain information includes runtime and configuration information of the local switch and
runtime information of the principal switch.
Examples
# Display the domain information of VSAN 1.
<Sysname> display fc domain vsan 1
Domain Information of VSAN 1:
Running time information:
State: Stable
Switch WWN: 41:6e:64:69:61:6d:6f:21
Fabric name: 41:6e:64:69:61:6d:6f:21
25