Zoneset Clone - HP 6127XLG Blade Series Command Reference Manual

Examples
# Create zone z1.
<Sysname> system-view
[Sysname] vsan 1
[Sysname-vsan1] zone name z1
# Add an N_Port with the FC address as 010000 to zone z1.
[Sysname-vsan1-zone-z1] member fcid 010000
[Sysname-vsan1-zone-z1] quit
# Create zone set zs1.
[Sysname-vsan1] zoneset name zs1
# Add zone z1 to zone set zs1.
[Sysname-vsan1-zoneset-zs1] member z1
[Sysname-vsan1-zoneset-zs1] quit
# Activate zone set zs1 and distribute it to the entire fabric.
[Sysname-vsan1] zoneset activate name zs1
Related commands
display zoneset active
•
zoneset distribute full
•

zoneset clone

Use zoneset clone to create a zone set by copying an existing zone set.
Syntax
zoneset clone src-name dest-name
Views
VSAN view
Predefined user roles
network-admin
Parameters
src-name: Specifies the name of the source zone set to be copied, a case-sensitive string of 1 to 64
characters. A source zone set name can contain English letters (uppercase and lowercase), numbers,
and special characters dollar sign ($), minus sign (-), caret (^), and underscore (_), and it must start with
an English letter.
dest-name: Specifies the name of the destination zone set, a case-sensitive string of 1 to 64 characters.
A destination zone set name can contain English letters (uppercase and lowercase), numbers, and
special characters dollar sign ($), minus sign (-), caret (^), and underscore (_), and it must start with an
English letter.
Usage guidelines
Only FCF switches and VSANs operating in FCF mode support this command.
Examples
# Create zone set zs1.
98