Table of Contents
Advertisement
Other Functions
Using the Self-cleaning Oven
•
On models which have this device, the self-cleaning oven differs from normal ovens because the inner surfaces are
coated with a special micro-porous enamel that absorbs and eliminates grease residues during cooking. If liquid
grease is released, self-cleaning is not sufficient, so wipe the grease stains with a damp sponge and then heat the
oven to the maximum temperature, wait for it to cool down and wipe again with a damp sponge.
Cleaning the Appliance
•
Before cleaning the appliance, it should be disconnected from the power supply and turned off the main gas feeder
valve.
Cleaning the work surface
•
Periodically clean the burner parts and trivets as listed below. Note that all parts must be thoroughly rinsed and dried
before being replaced.
•
Any liquid that overflows from pots must always be removed using a rag.
•
If it becomes difficult to open or close a valve, do not force it, but immediately contact the omega service department.
Cleaning the enamelled parts
•
The trivets and burner covers are cast iron with an enamel coating. To maintain the original features of the enamelled
parts they should be cleaned frequently with soapy water. Never use abrasive powders. Do note leave acidic or
alkaline substances on the enamelled parts (vinegar, lemon juice, salt, tomato sauce, etc.) and do not wash the
enamelled parts while they are still hot.
Cleaning the STAINLESS steel parts
•
Clean the parts with soapy water and then dry them with a soft cloth. The shine is maintained by periodically using
special products that generally are found in the market. Never use abrasive powders.
Cleaning the burner bodies
•
The aluminium burner bodies sit on the burner bases. Remove from the base and wash them with soapy water.
Rinse and dry, and check that all holes and slots are fully cleaned. Replace on the burner bases, taking care that they
are positioned and orientated correctly.
Cleaning the inside of the oven
•
To thoroughly clean the inside of the oven, it is recommended that the door be removed first. First lock the hinge in
place with the nail supplied (01-02). With the hinges fixed, grab both sides of the door and slowly work the door off
the hinges towards you. Once fully removed, place in a safe position until it is time to fix back in place (in the opposite
order). The internal rack guides can also be temporarily removed by undoing the screws holding them in place and
lifting out.
Baumatic BAF90EG 900mm Upright Oven User Manual 25
Hide quick links:
Advertisement
Table of Contents
