Table of Contents
Advertisement
Note: Once a carrier is in data mode, the Data Map becomes active for that carrier.
The Data Map serves as a routing table which maps incoming data to unique output
carriers.
To Configure the Data Map
1
Navigate to the Maps page.
2
In the tree menu, select Data Map.
Result: The following window is displayed.
3
Configure the Stream Type to be DOCSIS MPT without UDP for the desired
carrier.
Note: The Stream Type setting of the RFGW-1-D is dependent upon the rf-
channel configuration for the relevant controller modular-Cable in the CMTS.
The following table lists the valid Stream Type settings for each of the rf-channel
options in the uBR10K.
rf-channel (CMTS)
udp-port
depi-remote-id
In DOCSIS 2.0 Cisco Wideband operation, the eQAM device carries only
wideband channels (non-primary DOCSIS). For non-primary flows in DOCSIS
2.0 Cisco Wideband operation, rf-channels are typically configured as udp-ports
in the CMTS, and the valid Stream Type is MPEG. For DOCSIS 3.0 Cisco
Wideband operation, most operators are migrating to using depi-remote-id for
all rf-channels. This is done primarily to provide flexibility in defining primary
and non-primary channels. For flows defined as depi-remote-id in the CMTS,
the valid Stream Type is DOCSIS MPT w/o UDP.
78-4025112-01 Rev H0
Stream Type (RFGW-1-D)
MPEG
DOCSIS MPT w/o UDP
Provisioning
115
Advertisement
Table of Contents
