Making A Snapshot - Cisco C20 Administrator's Manual

Cisco TelePresence System Quick Set C20 / C20 Plus and Profiles using C20
Contents Introduction

Making a snapshot

When administrating the video system from a
remote location, you can use the web interface
snapshot feature to check the view of the main
video input source.
This feature is disabled by default. The feature
can be enabled only when you have direct
access to the codec, i.e. from the on screen
menu or by using the command line interface
via the codec serial data port.
Using the on screen menu
From the Advanced configuration menu,
navigate to Video > AllowWebSnapshots and
select On to enable the snapshot feature.
Using the command line interface
Enter the following command to enable the
snapshot feature:
xConfiguration Video
AllowWebSnapshots <Off/On>.
D14637.04 Profile C20 and Quick Set C20 Administrator Guide TC4.0, November 2010.
Copyright © 2010 Cisco Systems, Inc. All rights reserved.
Web interface Web interface Advanced configuration
The Snapshot page
How to make a snapshot
Press Get snapshot. The
1.
snapshot will be displayed on
the web interface.
Password protection
14
Administrator guide
Appendices Contact us
www.cisco.com