Replacing the Battery
Note: Before replacing the battery, read the
Identifying Your Model Type
Dolphin 70e Black model terminals equipped with a battery door lock are designed for use with
battery part numbers BAT-STANDARD-02 (Li-ion 3.7V, 6.179 watt hour) and BAT-EXTENDED-02
(Li-ion 3.7V, 12.358 watt hour) manufactured for Honeywell International Inc. See battery replacement
instructions below.
Back panel of the terminal
with standard battery door
shown.
Dolphin 70e Black model terminals not equipped with a battery door lock are designed for use with
battery part numbers BAT-STANDARD-01 (Li-ion 3.7V, 6.179 watt hour) and BAT-EXTENDED-01
(Li-ion 3.7V, 12.358 watt hour) manufactured for Honeywell International Inc. See page
replacement instructions.
Back panel of the terminal
with standard battery door
shown.
Replacing the Battery in Terminals Equipped with a Battery Door Lock
The following instructions are relevant for Dolphin 70e Black terminals equipped with a battery door lock.
If your Dolphin 70e Black terminal does not have a battery door lock, refer to the instructions
on page 2-17.
Ensure all components are dry prior to mating terminals/batteries with peripheral devices. Mating wet
components may cause damage not covered by the warranty.
Note: The following illustrations depict a standard battery with a standard battery door; however, battery removal/
installation procedures are the same for the extended battery and extended battery door.
1. Press the Power button
Guidelines for Battery Pack Use and Disposal
to place the terminal in Suspend mode.
on page 3-16.
Battery Door Lock
2-17
for battery
2 - 15