Troubleshoot In Import Failure - Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual

¢
Restrictions on import file modification
When switch module setting is executed without a switch module installed for
management module firmware version: A0120, the import fails. If so, delete
the following four lines from the setting file and then execute the import.
set sw-module mgmt-lan 0 -e int
set sw-module mgmt-lan 1 -e int
set sw-module mgmt-lan 2 -e int
set sw-module mgmt-lan 3 -e int
Restrictions on import file modification are as follows.
• Strictly follow the format.
If you add CLI command not included in the format or any command is
written in another place in the file, import may not be properly executed.
• Delete a command that you do not need to execute from the file.
• Setting description for import files is created with CLI command. For
details, see the Hitachi Compute Blade 500 Series CLI Console User's
Guide.
• When importing IPv6 address settings, use a management module whose
firmware version is A0230 or later. If you use a management module
whose firmware version is earlier than A0230, delete the IPv6 address
settings before importing the settings.
• You cannot set an IPv6 stateless address.

Troubleshoot in import failure

When import fails, check a message on Import (Result) to find a cause
shown there.
2-260
Hitachi Compute Blade 500 Series Management Module Setup Guide
set sw-module mgmt-lan 0 -e mgmt -i 192.168.0.31 -s
255.255.255.0 -g 192.168.0.100
Type of connection: external connection port of the switch module
set sw-module mgmt-lan 0 -e sw
Tip: When changing a switch module to set except switch module 0,
change the number 0 to 1 - 3.
Functional detail