Sce 2000 Mounting Brackets - Cisco 2000 4xGBE Quick Start Manual

2
Rack-Mounting the SCE 2000 Chassis
This chapter provides information for rack-mounting the SCE 2000 chassis.
Warning Before you install, operate, or service the system, read the
Cisco Service Control Engines
working with the system.

SCE 2000 Mounting Brackets

There are two standard types of equipment racks, and the appropriate brackets for each are provided in the enclosed kit.
• 19" rack with front rack posts — the mounting kit includes two mounting brackets as illustrated below:
Figure 2 Mounting Brackets
• 19" rack with front and back rack posts — in addition to the mounting brackets illustrated below, the mounting kit includes
two crossrail supports that the unit slides onto.
Figure 3 Crossrail Supports
The SCE 2000 mounts to the two front rack posts with brackets that attach to the front of the SCE 2000. The inside width
between the two posts or mounting strips (left and right) must be at least 17.3 inches (44 cm).
Remember to leave a two-inch (5 cm) clearance on both sides of the SCE 2000 and at the rear for adequate airflow for
Note
the inlet and exhaust vents.
(SCE). This guide contains important safety information you should know before
Regulatory Compliance and Safety Information for the
5