Cisco 2000 4xGBE Quick Start Manual page 22

After configuring the SCE platform, you may query for the running configuration using the command show running-config.
Step 1 At the SCE# prompt, type show running-config. The system shows the running configuration.
SCE#show running-config
#This is a general configuration file (running-config).
#Created on 13:39:29
#cli-type 1
#version 1
hostname "SCE-2020-1"
enable password level 5 0 "admin"
enable password level 10 0 "admin"
enable password level 15 0 "admin"
no management-agent notifications notification-list 1417,1418,804,815,1404,1405,1406,1407,1408,400
no management-agent notifications notification-list 402,421,440,441,444,445,446,450,437,457
no management-agent notifications notification-list 3593,3594,3595,10040
snmp-server enable
interface LineCard 0
connection-mode inline on-failure bypass
no silent
no shutdown
flow-filter partition name "ignore_filter" first-rule 4 num-rules 32
flow-filter partition name "udpPortsToOpenBySw" first-rule 40 num-rules 21
attack-filter subscriber-notification ports 80
replace spare-memory code bytes 3145728
interface FastEthernet 0/0
ip address 172.29.52.245 255.255.255.0
interface FastEthernet 0/1
ip address 172.29.52.245 255.255.255.0
interface GigabitEthernet 0/1
auto-negotiate
global-controller 0 name "Default Global Controller"
interface GigabitEthernet 0/2
auto-negotiate
global-controller 0 name "Default Global Controller"
interface GigabitEthernet 0/3
global-controller 0 name "Default Global Controller"
interface GigabitEthernet 0/4
global-controller 0 name "Default Global Controller"
exit
ip default-gateway 172.29.52.1
22
UTC TUE July 7 2009