Connecting The Management Interface - Cisco 2000 4xGBE Quick Start Manual

Connecting the Management Interface

Figure 15 Cabling the Management Port
MN G 1
MN G 2
CO NS OL
E
LIN K/
10/1 00/
ACT IVE LIN K/
100 0 10/1 00/
ACT IVE
100 0
1 2 3
By default, the management port is configured to auto-negotiation enabled.
Note
The SCE 2000 has two management ports, labeled Mng1 and Mng 2. Use the Mng 1 port.
Plug the Ethernet cable provided (with attached RJ-45 connector) into the Mng 1 port on the front panel of the
Step 1
SCE 2000.
Connect the other end of the Ethernet cable into your management network. The Link LED on the SCE 2000
Step 2
management port lights.
Test connectivity. From the host that you intend to use for remote management, ping to the SCE 2000 by typing ping
Step 3
and the SCE 2000 IP address, and pressing Enter.
This verifies that an active connection exists between the specified station and the management port.
16
PW R A
PW R B
STA TU S
BY PAS S
C is co S
AU X LIN K RX 4 xG B E
TX
LIN K RX
TX
LIN K RX
TX
RX
MM
TX
RX
MM
TX
RX
MM
TX
RX
GB E-1
SU B
LIN E
NE T
GB E-2
SU B LIN
E/C AS CA
DE NE T
C E 2 0 0 0
Se rie s
LIN K RX
TX
MM
TX