Makita DRC200 Instruction Manual page 70

Operation
Check that the Robotic Cleaner is in standby mode.
1
Select the cruise mode and other settings, and begin
cleaning.
Operation
1. Select the cruise
mode.
2
2. Select vacuum
fan ON/OFF.
3. Select buzzer
volume.
4. Begin cleaning.
Note: The settings are maintained until the next time they are
changed.
Setting the auto-on start time
Check that the Robotic Cleaner is in standby mode before
setting the start time.
Setting the auto-on timer
1. Select the cruise mode.
2. Select the start time.
Remote
Cleaner
Auto-on
or
time
Pressing the button cycles
through the following
settings.
After
1 hour
After
3 hours
After
5 hours
Auto-on
timer
disengaged
Adjusting the buzzer volume
Perform the following operation in standby mode to set the
buzzer volume while cleaning.
Cleaner
Remote control
or
Pressing the button makes the
buzzer beep and cycle through
the following settings.
High volume
Low volume
No sound (mute)
Note: For details, refer to the INSTRUCTION MANUAL.
Cleaner
Remote control
Pattern mode
The selected mode
↑ ↓
lamp lights up.
Random mode
See the front side of this sheet.
See below.
3. Activate the
auto-on timer.
Cleaner
control
Timer
lamp
or
The Robotic Cleaner
enters sleep mode, and
then starts cleaning
automatically when the
set time has elapsed.
Buzzer lamp on the
Lights up
Lights up
The Robotic Cleaner accepts the start operation and then
starts cleaning.
3
or
When the battery power becomes low, the Robotic
Cleaner stops in place. Once the Robotic Cleaner has
been stopped for approx. 5 minutes, it automatically
enters sleep mode.
4
The Robotic Cleaner automatically turns OFF after the
following periods have elapsed.
When using two BL1830s: After approx. 60 hours
When using two BL1850s: After approx. 100 hours
Note: The time until the power turns OFF may differ depending on the
Cruise mode
Cruise mode
Pattern mode
Remote
Random mode
control
Using the location-beacon feature
Press the Location beacon button on the remote control. The
Robotic Cleaner's buzzer will beep and the pilot lamp will flash,
helping you to locate the Robotic Cleaner.
cleaner
Remote control
To stop the buzzer and flashing, press the Location beacon
button again.
Off
The buzzer beeps and the pilot
lamp flashes during cleaning.
To pause cleaning partway
Cleaner
After cleaning has been paused, press the Start/
Stop button on the remote control or the POWER
(start/stop) button on the Robotic Cleaner again to
restart cleaning in the same cruise mode as before
cleaning was paused.
battery status, room temperature, and other factors.
For cleaning wide spaces with few obstacles.
(Ex.) well-organized warehouses, long corridors, etc.
Cleaning can be performed more efficiently by
starting the Robotic Cleaner from a position at the
closer end of the left wall.
For cleaning locations with many obstacles.
(Ex.) offices, etc.
The buzzer beeps for approx. 10 seconds
and the pilot lamp flashes.
Remote control
or
Description