Add Additional Participants To Existing Call - Cisco TelePresence DX70 User Manual

17
Conference Calls with Multiple Participants

Add Additional Participants to Existing Call

Assume that you already are in
a call. This call may have been
initiated by you or by someone
else (someone called you). Tap
Add.
This new call will now be
added to the existing.
This is an optional feature that may, or may not, be available for your system.
Locate whom to call, in the
usual way.
You have now established a
conference.
You may repeat this procedure
to the extent permitted by your
video infrastructure.
Place the call, in the usual way.
You may alter the Call settings
of that call before you place
it—see side bar for more.
About Video Conferences
Your video system network may
be equipped with the capability to
initiate a video conference with
several participants.
The maximum number of participants
supported by your video system will
depend on system configuration and
the video infrastructure. If in doubt,
contact your video support team.
If you want to initiate a video
conference, you must call each
participant one by one.
If you are the one who initiated
the conference you will be able to
terminate the entire conference.
The other participants may only
disconnect themselves from the
conference.
Call settings. Those you call may
have video systems with different
bandwidths. You are not constrained
to set all participants to a bandwidth
that all systems support. The Call
rate may be set individually for all
participants in order to provide
everyone with the best quality
available for their system. See
"Change Call Rate" on page 14.
D1510413 User Guide
Cisco TelePresence DX70, DX80
Produced: April 2016 for CE8.2
All contents © 2010–2016
Cisco Systems, Inc. All rights reserved.