Makita MUH355 Instruction Manual page 8

1
1. Blade cover
010421
7. Install the new shear blades on the tool as follows.
Overturn the shear blades. Secure them with
three screws and then remove the remaining one
that has been used for temporarily securing the
blades and secure them with it.
1
2
4
1. Overturn the blades
2. Crank
3. Align the longer side of crank with marking on the gear
housing.
4. Place the crank so that these lines are parallel each
other.
010422
8. Tighten the screws firmly.
010420
9.
NOTE:
•
Storage
The hook hole in the bottom of the tool is convenient for
hanging the tool from a nail or screw on the wall.
010369
Put the blade cover on the shear blades so that the
blades are not exposed. Store the tool out of the reach of
children carefully.
Store the tool in the place not exposed to water and rain.
To maintain product SAFETY and RELIABILITY, repairs,
3
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
8
Remove the blade cover and then turn on the tool
to check it for proper movement.
When the shear blades does not operate properly,
there is a poor fit between the blades and crank.
Redo from the beginning.
1
1. Hook hole