Page 1
Mesin Profil PETUNJUK PENGGUNAAN Pemangkas MANUAL ARAHAN Máy Đánh Cạnh Cầm Tay Hoạt Động Bằng Động Cơ TÀI LIỆU HƯỚNG DẪN Điện เครื ่ อ งฉลุ ล ายไม้ ไ ฟฟ้ า คู ่ ม ื อ การใช้ ง าน M3702...
ENGLISH (Original instructions) SPECIFICATIONS Model: M3702 Collet chuck capacity 6.35 mm (1/4") or 6.0 mm No load speed 35,000 min Overall height 211 mm Net weight 1.5 kg Safety class • Due to our continuing program of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country. • Weight according to EPTA-Procedure 01/2014...
Page 8
Do not abuse the cord. Never use the cord for Always wear protective goggles to protect carrying, pulling or unplugging the power tool. your eyes from injury when using power tools. The goggles must comply with ANSI Z87.1 in Keep cord away from heat, oil, sharp edges or moving parts.
Keep handles and grasping surfaces dry, 18. Some material contains chemicals which may clean and free from oil and grease. Slippery be toxic. Take caution to prevent dust inhala- tion and skin contact. Follow material supplier handles and grasping surfaces do not allow for safe handling and control of the tool in unexpected safety data.
Unintentional restart proof NOTE: Moving the tool forward too fast may cause a poor quality of cut, or damage to the trimmer bit or The tool does not start with the switch lever in I position motor. Moving the tool forward too slowly may burn even when the tool is plugged. and mar the cut. The proper feed rate will depend on At this time, the indication lamp blinks in red and shows the bit size, the kind of workpiece and depth of cut.
► Fig.15 CAUTION: These accessories or attachments are recommended for use with your Makita tool Attach the chip deflector on the groove of the specified in this manual. The use of any other base. accessories or attachments might present a risk of Install the trimmer guide and guide holder on the injury to persons. Only use accessory or attachment...
Page 12
Drill point double flush trimming bit Ball bearing chamfering bit ► Fig.24 ► Fig.30 θ 45° 1/4" 1/4" 60° Unit:mm Unit:mm Corner rounding bit ► Fig.25 Ball bearing beading bit ► Fig.31 1/4" 1/4" Unit:mm Unit:mm Ball bearing cove beading bit ► Fig.32 Chamfering bit ► Fig.26 θ...