Troubleshooting; Troubleshooting Guide - Honeywell 10 kW Owner's Manual

Air-cooled automatic standby generators
Hide thumbs Also See for 10 kW:
Table of Contents

Advertisement

Troubleshooting
5.1
TROUBLESHOOTING GUIDE
Problem
Cause
The engine will not crank.
1.
Fuse blown.
2.
Loose, corroded or defective
battery cables.
3.
Defective starter motor.
4. Dead Battery.
Correction
1.
2.
3.
Correct short circuit condition, replace 7.5A
fuse in generator
control panel.
Tighten, clean or replace
as necessary.
4. Charge or replace battery.
The engine cranks but
1.
Out of fuel.
1.
Replenish fuel/Turn on fuel valve.
will not start.
2.
Defective fuel solenoid (FS).
2.
*
3.
Open #14 wire from
engine control board.
3.
*
4.
Fouled spark plug(s).
4.
Clean, re-gap or replace plug(s).
5.
Valve lash out of adjustment.
5.
Reset valve lash.
6.
Choke not operating.
6.
Verify choke plate moves freely.
The engine starts hard
1.
Air cleaner plugged
1.
Check, replace aircleaner.
and runs rough.
or damaged.
2.
Fouled spark plug(s).
2.
Clean, re-gap or replace plug(s).
3.
Fuel pressure incorrect.
3.
Confirm fuel pressure to regulator
is 10-12" water column (0.36-0.43 psi) for
LR and 5-7" water column (0.18-0.25 psi)
for natural gas.
4.
Fuel selector in wrong position.
4.
Move selector to correct position.
5.
Choke remains closed.
5.
Verify choke plate moves freely.
The AUTO/OFF/MANUAL
1.
Defective switch.
1.
*
switch is set to OFF, but
2.
AUTO/OFF/MANUAL switch
2
*
the engine continues
wired incorrectly.
to run.
3.
Defective control board.
3.
*
There is no AC output
1.
Main line circuit breaker is in
1.
Reset circuit breaker
from the generator.
the OFF (or OPEN) position.
to ON (or CLOSED).
2.
Generator internal failure.
2.
*
There is no transfer to
1.
Defective transfer switch coil.
1.
*
standby after utility
2.
Defective transfer relay.
2.
*
source failure.
3.
Transfer relay circuit open.
3.
*
4.
Defective control logic board.
4.
*
Unit consumes large
1.
Engine over filled with oil.
1.
Adjust oil to proper level.
amounts of oil.
2.
Improper type or viscosity of oil.
2.
See "Engine Oil Recommendations".
3.
Damaged gasket, seal or hose.
3.
Check for oil leaks.
4.
Engine breather defective.
4.
*
'Contact the nearest Dealer for assistance.
26

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

12 kw15 kw20 kw

Table of Contents