Specifications; Additional Safety Rules - Makita LC1230 Instruction Manual

ENGLISH
1 Base
2 Wrench holder
3 Hook
4 Bolt
5 Center cover
6 Hex bolt
7 Safety cover (Safety guard)
8 Socket wrench
9 Shaft lock
10 Hex bolt
11 Spindle

SPECIFICATIONS

Model
Blade diameter ....................................................................................................................................................305 mm
Hole (arbor) diameter .........................................................................................................................................25.4 mm
-1
No load speed (min ).............................................................................................................................................. 1,300
Dimensions (L x W x H) ........................................................................................................ 516 mm x 306 mm x 603 mm
Net weight .............................................................................................................................................................19.0 kg
Cutting capacity
Workpiece shape
Cutting angle
90°
45°
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for cutting in mild steel and stainless
steel with appropriate saw blades.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.25 Ohms it can be presumed that
there will be no negative effects.
The mains socket used for this device must be protected
with a fuse or protective circuit breaker having slow trip-
ping characteristics.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.
Explanation of general view
12 Inner flange
13 Carbide-tipped saw blade
14 Outer flange
15 Lever
16 Loosen
17 Tighten
18 Vise stop
19 Indicator
20 Graduation
21 Vise plate
22 Vise nut
115 mm
90 mm

ADDITIONAL SAFETY RULES

1.
2.
3.
4.
5.
6.
7.
8.
9.
23 Vise handle
24 Lever
25 Lock-off button
26 Handle
27 Switch trigger
28 Dust box
29 Limit mark
30 Screwdriver
31 Brush holder cap
Always use safety glasses, dust mask and ear
protector.
Use only Makita genuine carbide-tipped saw
blade 305 mm in diameter for metal cutting.
Never use abrasive cut-off wheel or other type of
saw blades.
Check the blade carefully for cracks or damage
before operation. Replace cracked or damaged
blade immediately.
Never secure the safety cover (safety guard).
Always be sure that the safety cover moves
smoothly before operation. Any irregular opera-
tion of the safety cover should be corrected
immediately.
Do not use the saw without guards in position.
Be sure shaft lock is released before the switch
is turned on.
Before using the tool on an actual workpiece, let
it run for a while. Watch for vibration or wobbling
that could indicate poor installation or a poorly
balanced blade.
Keep your hands and body away from rotating
blade.
Always secure the workpiece with the vise.
Make sure the blade is not contacting the work-
piece before the switch is turned on.
LC1230
75 mm x 150 mm
100 mm x 100 mm
85 mm x 85 mm
7