Settings Relating To Function Links (Link Menu) - Sony DVS-9000 User Manual

Auto: When the pattern limit is released, the remainder of the transition is
Manual: After the pattern limit is released, the transition waits for the next
Setting the default wipe edge softness
Use the following procedure.
In the Switcher>Key/Wipe/FM menu, adjust the following parameter to set the
default value.
Knob
3
Automatically naming and saving to frame memory
In the Switcher>Key/Wipe/FM menu, press [FM Auto Store], turning it on.

Settings Relating to Function Links (Link Menu)

Carry out setup relating to links by displaying the Switcher>Link menu.
To display the Link menu
In the Engineering Setup menu, select VF3 'Switcher' and HF6 'Link.'
The status area shows the current link information.
Setting a cross-point button link
To link together two buses internal to the switcher, use the following
procedure.
1
2
114
Setup Relating to Switcher Processor
carried out automatically at a special-purpose transition rate.
operation, then executes. Until you move the fader lever or press [AUTO
TRANS], the transition is not executed.
Parameter Adjustment
Wipe Edge Default value of wipe edge softness
Soft
In the Switcher>Link menu, press [Internal Bus Link].
The Internal Bus Link menu appears.
The status area shows the link source and link destination buses, and link
table information.
Using any of the following methods, select what setting applies to.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn knob 1 to make the setting.
Setting values
–
50.00 to +50.00