Signal Output Settings (Output Config Menu) - Sony DVS-9000 User Manual

5
Carrying out level settings
To set the low level and high level, first set the trigger type to "Level," then use
the following procedure.
1
2
3

Signal Output Settings (Output Config Menu)

For the DCU parallel output ports, after carrying out tally settings in the
Router/Tally>Tally Enable menu, you can assign GPI outputs to output ports
that are still unused.
To assign DCU outputs to DCU parallel output ports, display the DCU>Output
Config menu.
130
Setup Relating to DCU
• Action list when the trigger type is "Level"
Simul, Custom , Format (frame/field rate, number of lines)
(System Format, SWR Format, DME Ch1-Ch4 Format
Aspect (System Aspect, SWR Aspect, M/E-1 Aspect, M/E-2 Aspect,
M/E-3 Aspect, P/P Aspect, DME Ch1-Ch4 Aspect
DME Ch1 Aspect, DME Ch2 Aspect, DME Ch3 Aspect, DME Ch4 Aspect
No Action
b) When knob 2 selection is "Snapshot"
c) When knob 2 selection is "Effect"
To confirm the setting in step 4, press [Action Set].
This confirms the setting, which appears in the status area.
In the DCU>GPI Input Assign menu, select the action to be set, and press
[H/L Set].
The H/L Set menu appears.
Using any of the following methods, select the settings.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn knob 1 to make the setting.
Knob Parameter
1 No
To apply the selection made in step 2 when the input is the GPI high level,
press [H Set]. To apply the selection made in step 2 when the input is low,
press [L Set].
This confirms the setting, which appears in the status area.
Adjustment
Signal format/screen aspect ratio
selection
Setting values
1 to ...