Makita LS1013 Instruction Manual page 12

ASSEMBLY
2
1. Socket wrench
2. Wrench holder
1. Stopper pin
1
2
3
1. Center cover
2. Hex bolt
3. Socket wrench
4. Blade guard
12
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Socket wrench storage
001530
The socket wrench is stored as shown in the figure. When
using the socket wrench, pull it out of the wrench holder.
After using the socket wrench, return it to the wrench holder.
1
Installing or removing saw blade
CAUTION:
• Always be sure that the tool is switched off and
unplugged before installing or removing the blade.
• Use only the Makita socket wrench provided to install or
remove the blade. Failure to do so may result in
overtightening or insufficient tightening of the hex bolt.
This could cause an injury.
Lock the handle in the raised position by pushing in the stop-
001564
per pin.
1
To remove the blade, use the socket wrench to loosen the
001532
hex bolt holding the center cover by turning it counterclock-
wise. Raise the blade guard and center cover.
4