Wiring Diagram - Makita DDF481 Technical Information

W
iring diagram
Fig. D-2
Place Connector this space among Rib A,
Rib B and Boss.
Thick lead wires from Stator
must be put on the other thin
lead wires.
Front view around the lead wires for LED circuit after setting Gear assembly in place
Note:
Be sure to route the lead wires for LED circuit
to the space between ribs of Gear assembly
after setting Gear assembly in place.
If the routing is done before assembling Gear
assembly, the breakage or pinching of the lead
wires will happen.
View before setting Switch and F/ R change lever in place
Rib A
Stator
Lead wires for LED circuit
A'
LED circuit
A
See the following illustration
for the cross section
between A and A'.
Rib B
Boss
Ribs of Gear assembly
P 8/ 11
LED circuit
(Insert it
as drawn above,)